Edelbrock Part # 2716 Performer EPS Vortec intake manifold is now available for small-block Chevys with Vortec or Edelbrock E-Tec cylinder heads, the Performer EPS dual-plane manifold is optimized to deliver superior performance with Edelbrock square-bore Performer Series or Thunder Series AVS carburetors. The runner design is “tuned” for peak torque around 3500 rpm on a 350-inch engine and it’s ideal for power from off-idle to 5500 rpm. Dyno tests showed gains averaging 5+ ft-lbs. of torque from 3000 to 4500 rpm for more performance where you need it most. Match with a dependable Edelbrock square-bore carburetor for maximum performance gains. Will not fit under stock Corvette hood.
| Application |
Application Specific |
| UPC |
00085347027163 |
| Gasket Or Seal Included |
No |
| Availability Note |
Available to Order |
| Warranty |
12 Months |
|
|
|
|
| Installation Notes |
- Manifold ht: A-3.87", B-5.28
- Carb pad height: 4.57"
- Carb recommendations: Edelbrock AVS2 or Performer Series 500-650 cfm
- Port exit dimensions: 2.05" tall with slanted side walls.
- Recommended intake gasket: Edelbrock # 7235
- Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant # 1076, DO NOT USE END SEALS GASKETS.
- Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.
- NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.
- DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.
- Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
- Will not fit under stock Corvette hood.
- Even though manifolds are compatible with EGR systems, this does not mean they are legal for use on emissions controlled vehicles. Check local laws for legality.
- Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
|
| Center Maximum Height |
3.200 in |
| CNC Ported |
No |
| Finish |
Satin |
| Front Maximum Height |
2.500 in |
| Material |
Aluminum |
| Rear Maximum Height |
3.900 in |
| Single Or Dual Plane Type |
Dual Plane |
